Kitchen remodeling
Bathroom remodeling
Home additions & ADU
Roofing
Windows & doors
Driveway & pavers
FenceFree written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
CertainTeed Kitchen Remodeling: The Oakland Owner’s Guide
We install kitchen remodels built around CertainTeed systems, and an Oakland kitchen of this kind typically runs $14,000 – $45,000 depending on cabinet layout, countertops, and whether the work touches plumbing or electrical. CertainTeed in a kitchen context means tile backer board, gypsum, trim, and insulation, the materials behind the finished surfaces, not the cabinets or counters themselves. We’re an independent service provider and not affiliated with CertainTeed.
Owners usually find out something failed one of two ways. Either a backsplash tile pops loose over a section of wall where the substrate flexed, or a remodel from years back starts showing soft drywall and hairline cracks near a sink or cooktop penetration. Both trace back to the same handful of material and installation failures we see across Oakland kitchens.
- Kitchen remodel, full scope: $14,000 – $45,000
- Small kitchen remodel: $9,000 – $20,000
- Cabinet installation: $4,000 – $13,000
- Countertop installation: $2,000 – $6,500
- Backsplash installation: $800 – $2,500
- Kitchen island installation: $3,000 – $10,000
Which CertainTeed Models This Applies To
CertainTeed’s kitchen-relevant materials break into distinct product lines, and matching the right one matters more than most homeowners expect. Backer board for wet and tile areas comes in specific thicknesses – 1/4-inch for floors and 1/2-inch for walls – and CertainTeed’s board is sized to match standard cement-board dimensions, which is where a compatibility gotcha lives: if a previous installer used a thinner board or a different brand under your backsplash, we can’t simply lay the same tile over it. The substrate has to be brought back to a consistent plane or the tile cracks again.
For drywall and ceiling work, CertainTeed gypsum board is stamped with thickness and type on the board’s edge tape, usually visible in an unfinished garage, closet, or attic penetration. Trim and corner bead follow standard dimensions, so matching is straightforward. The harder call is insulation: CertainTeed fiberglass batts in wall cavities are labeled with an R-value, and if your kitchen’s exterior wall was opened at some point, we check that label before deciding whether the existing insulation stays or gets upgraded during the remodel.
On the OEM-versus-aftermarket question, CertainTeed-compatible backer board and gypsum from other reputable manufacturers perform comparably when thickness and rating match, so we source by specification, not brand loyalty. We don’t stock parts or carry them on a truck; materials are ordered to your project’s measurements.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your CertainTeed Kitchen Remodeling Is Failing
These are the failures we actually get called about in Oakland kitchens, and each one points to a specific cause worth understanding before you spend money.
- Tile lifting or hollow-sounding over a backsplash. Usually a substrate that flexed because the board was too thin or wasn’t fastened to spec. Once the bond breaks, re-grouting won’t hold it.
- Hairline cracks radiating from a sink or cooktop cutout. Moisture has reached the drywall or board edge at a penetration that wasn’t sealed properly. Left alone, the crack widens and the wall behind softens.
- Soft or crumbly drywall near the sink. A slow leak or splash zone that was never protected with the right board. This one gets worse quietly, and by the time it’s visible the damage is usually 6-12 inches wider than it looks.
- Ceiling stains or sagging below an upstairs bathroom. Not a kitchen material failure at all, but a plumbing leak above that’s soaking the kitchen ceiling board. We trace it before replacing anything.
- Drafty exterior kitchen walls or condensation on the inside face. Missing or compressed insulation in the wall cavity, which is common in older Oakland homes where a kitchen was added or opened up without a proper insulation upgrade.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included
Bringing a failed kitchen substrate or backsplash back to solid usually falls into the backsplash installation range of $800 – $2,500 if the damage is isolated, or folds into a full kitchen remodel at $14,000 – $45,000 if the failure has spread behind cabinets or into the wall structure. Cabinet installation runs $4,000 – $13,000, countertop installation $2,000 – $6,500, and a kitchen island installation $3,000 – $10,000 when the layout calls for one.
What drives the range: how much tile and board has to come out, whether plumbing or electrical has to be moved, and whether the wall behind the failure is sound. Our pricing is upfront and itemized, the number you see is the number you pay, and every project carries the 730-Day Done Right Promise. Financing at 0% for 18 months and $1,000 off projects over $10,000 are available.
DIY or Call Us?
Some things you can safely check yourself: look for the thickness stamp on any exposed board edge, press along the backsplash to feel for hollow spots, and check the wall cavity insulation label if you can see it through an outlet or penetration. What you shouldn’t do yourself is tear out tile and board around a sink or cooktop without knowing whether a live electrical line or plumbing connection sits behind it. That’s where DIY goes wrong, and it’s a genuine safety issue, not a scare tactic. Call us at (833) 997-7759 and we’ll walk you through what’s actually failing before you commit to anything. Estimates are free.
FAQs
Twenty to thirty years is realistic when it’s installed correctly and kept dry, but Oakland’s wet winters and the moisture that collects near sinks and cooktops shorten that significantly if the seal at penetrations fails. Properly installed and protected board outlasts the tile on top of it.
Sometimes, if the failure is confined to one or two tiles and the board behind them is still solid. Once the board itself is soft or the tile is lifting across a whole section, repair won’t hold and replacement is the honest answer. Call (833) 997-7759 and we’ll tell you which situation you’re in.
An isolated backsplash replacement typically runs two to four days including cure time; a full kitchen remodel that includes substrate work runs several weeks depending on scope. We give you a real timeline with the estimate, not a guess.
We order to your project’s measurements after confirming board thickness, insulation R-value, and finish requirements on site, so nothing is guessed. We don’t stock parts or carry them on a truck, which means the material matches your kitchen rather than whatever was on hand. Call (833) 997-7759 to schedule your free estimate.
When your Oakland kitchen needs work done right, from backsplash to full remodel, we answer the phone with a live person 24/7, send background-checked technicians in uniform, and back the whole job with a 730-Day Done Right Promise. We also work with KraftMaid, Cambria, and Silestone for cabinetry and countertops when your project calls for them. Call (833) 997-7759 to schedule your free estimate and design consult.
Written by the team at Groundwork Construction Co. of Oakland, serving Oakland and nearby areas.