Kitchen remodeling
Bathroom remodeling
Home additions & ADU
Roofing
Windows & doors
Driveway & pavers
FenceFree written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Vanities, Tile & Fixtures in Oakland: What the Job Actually Costs and How Long It Takes
Vanities, tile and fixtures work in Oakland typically runs $9,000 to $28,000, and most of our jobs finish in three to five weeks once materials are on site. That range covers new vanities, floor and wall tile, and the fixtures that go with them (faucets, shower valves, drains, trim). Smaller scopes, like a vanity swap plus a tile backsplash, land near the bottom. A full gut of a Rockridge bathroom with heated floors, a custom vanity and imported tile lands at the top. Call (833) 997-7759 and we’ll walk your project and give you a written, line-item number.
Stage by Stage: How We Do Vanities, Tile & Fixtures Work
Coastal air is the reason this job goes sideways if you rush it. In the flats near Alameda and the fog belt stretching up through Temescal, we see hinges, rollers and vanity hardware pit and seize years before inland hardware does. So corrosion control shapes the whole schedule, not just the finish.
Stage 1: Walk, measure, and decisions (day 0)
We measure the room, check for water damage around the toilet flange and vanity, and photograph the subfloor. You decide the vanity size and material, the tile layout, and fixture finishes during this visit or in the week after. We give you a written line-item estimate so the numbers are in front of you before anyone touches a tool.
Stage 2: Demo and rough-in inspection (days 1 – 2)
We tear out the old vanity, tile and fixtures, then inspect the subfloor and framing. In older Oakland homes this is where surprises live: a soft subfloor, unpermitted framing, or a drain that doesn’t line up with the new vanity. If we’re moving plumbing or wiring, this is when it gets roughed in and inspected. Permit turnaround in Oakland can add a week or more, depending on the scope.
Stage 3: Substrate, waterproofing, and corrosion guard (days 3 – 5)
We install cement backer board in wet areas, seal the shower pan and wall corners with a waterproofing membrane, and swap in galvanized fasteners and stainless hardware everywhere you’ll have moisture. Those parts cost a little more upfront and outlast standard hardware by years in coastal air.
Stage 4: Tile, vanity, and fixture set (days 6 – 18)
Tile goes down, grout cures, vanity gets set and leveled, mirror and light go up, then fixtures: faucets, drain, shower valve, trim. This is the longest stage and where delays come from dried adhesive, not labor. Most tile setting is five to seven working days per room.
Stage 5: Final walk and warranty close-out (day of completion)
We check every drain, every faucet, every grout line, and confirm the vanity doors and drawers open clean. You get a final walkthrough, any touch-ups are done, and the work is covered by our 730-Day Done Right Promise: if it’s not done right, we make it right.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The Options You’ll Choose Between for Oakland Bathrooms
- Vanity: solid wood vs. plywood vs. MDF core. Solid wood and plywood hold up to moisture and last decades. MDF is cheaper but swells in damp air, which is a real risk in a Pacific-facing Oakland bathroom.
- Countertop: quartz vs. marble vs. granite. Quartz is low-maintenance and consistent. Marble looks great but stains and etches. Granite holds up well and hides water spots.
- Floor tile: porcelain vs. natural stone. Porcelain handles moisture and daily wear with almost no upkeep. Natural stone needs sealing every year or two and costs more.
- Wall tile and shower surround: ceramic vs. porcelain vs. glass mosaic. Ceramic is the most affordable. Porcelain is denser and more water-resistant. Glass mosaic is beautiful but costs more and requires careful grouting.
- Fixtures: standard chrome vs. brushed nickel/black stainless vs. solid brass. Chrome is affordable and easy to clean but pits faster in salt air. Brushed finishes hide water spots. Solid brass costs the most but resists corrosion longest.
- Small extras: heated floor mat vs. towel warmer vs. neither. Heated floors add comfort in a Bay Area bathroom; a towel warmer does less for the money.
We source from names like Kohler for fixtures and KraftMaid for vanities because the parts hold up. If you want a specific brand, tell us in the estimate and we’ll price it.
What Vanities, Tile & Fixtures Costs in Oakland, CA
Written estimates here run $9,000 to $28,000. That covers demo, substrate and waterproofing, tile, vanity and fixtures, and cleanup. What moves you to the high end:
- Room size and tile area. A small hall bath lands near $9,000. A large master with full wall tile pushes $28,000.
- Existing condition. Water damage, soft subfloor or old galvanized drain lines add real dollars. So do century-old walls in a 1920s Craftsman.
- Relocating plumbing or wiring. Moving a drain or adding a vanity outlet means rough-in work and possibly a permit, which adds cost and a week.
- Material grade. Entry tile and a stock vanity sit low. Imported stone and a custom vanity sit high.
- Corrosion-resistant hardware. Stainless and galvanized parts add modest cost and help you avoid corrosion replacement later. We spec them by default on Oakland jobs.
Every estimate is line-item, so you see what’s included and what isn’t. We don’t hand you a lump-sum number and disappear.
See the difference
Before
After
Before
After
Before
AfterWhat Oakland Homes Specifically Do to Vanities, Tile & Fixtures
Most Oakland bathrooms we open were built between 1900 and 1940, and the remodel has to work around what those houses left behind. In a Temescal bungalow you might find knob-and-tube wiring to the vanity light. In West Oakland row houses we regularly find a toilet flange that was never leveled and a subfloor patched by a previous owner. In the hills, walls come down and we find framing that needs seismic attention before we finish the tile. Oakland’s building department may require an engineering letter for even modest structural changes in pre-1970 homes, which can add weeks to the schedule. That’s why we quote after we look, not before. If you’re weighing a much broader project alongside this one, our Bathroom Remodeling in Oakland page covers what a full design-build looks like. And because we’re also a roofing contractor across Oakland, if your winter leaks trace back to the roof, we can inspect that too.
Serving Oakland, CA – Our Local Coverage Area
We serve Oakland and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked – Vanities, Tile & Fixtures in Oakland, CA
Three to five weeks for a typical bathroom. Demo and rough-in take a couple of days, tile and fixture setting takes two to three weeks, and the schedule stretches if the city requires a permit or an engineering letter for pre-1970 homes. Call (833) 997-7759 to get a real timeline for your room.
It depends on the scope. A vanity swap and a tile backsplash usually don’t need a permit. Moving plumbing or wiring, or a full bathroom gut, almost always does, and Oakland’s building department can require an engineering letter for structural changes in older homes. We tell you up front what’s permitted and what isn’t. Call (833) 997-7759 for a free permit review.
Usually, yes. If the vanity footprint and the existing drain line match, the job is a straight swap, which keeps cost near $9,000 – $13,000 and finishes faster. We measure to confirm before we quote. Call (833) 997-7759 to set up the measure.
Plan on $1,500 – $4,000 extra, depending on how far the drain moves and whether the subfloor has to be opened. That range sits on top of the $9,000 – $28,000 base job. Call (833) 997-7759 for an exact number.
Our 730-Day Done Right Promise: if it’s not done right, we make it right, for two years. That covers workmanship on tile, vanity installation, plumbing connections and fixture set. Material warranties come from the manufacturer and we hand you the paperwork. Call (833) 997-7759 with questions.
Get a Free Estimate for Vanities, Tile & Fixtures in Oakland
Call (833) 997-7759 for a free on-site estimate. A live person answers around the clock, so you’ll get a real human on the phone, not a voicemail. We’ll walk the room, discuss material choices, and leave you with a written line-item number and a clear timeline. If you’re also planning a roof project, ask about pairing this with Tile Roofing in Oakland or Specialty Roofing in Oakland. You can also read our full Bathroom Remodeling service page for the wider scope.
Written by the team at Groundwork Construction Co. of Oakland.