Kitchen remodeling
Bathroom remodeling
Home additions & ADU
Roofing
Windows & doors
Driveway & pavers
FenceFree written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Door Installation in Emeryville, CA: What It Costs and How Long It Takes
Door installation in Emeryville, CA typically runs $650 to $3,200 per door, with most single-door projects finished in one to two days once the door is on site. That range covers removal of the old slab or prehung unit, framing adjustments, hardware fitting, weather sealing and finish trim. Entry doors with sidelights and custom sizing push toward the top of the range; a straightforward interior prehung door sits near the bottom. Call (833) 997-7759 to schedule a free on-site estimate, and you’ll get a written line-item quote before anything gets ordered.
How our Door Installation process actually runs, start to finish
No two doors install the same way, but the sequence doesn’t change much. Here’s what the week looks like on a typical Emeryville job.
Stage 1: Site visit and measurement (about 45 minutes). We measure the rough opening, check the wall for plumb and square, and look at what’s behind the trim. On older cottages west of San Pablo Avenue, that last part matters most, because you can find shims, furring strips, or a wall that was never square to begin with. You decide the door style, material, and swing direction at this visit.
Stage 2: Ordering and lead time (3 days to 4 weeks). Stock interior doors can be ready in days. A custom entry door from a manufacturer like Therma-Tru or ViewLux runs several weeks. You’ll approve the final spec and finish before we order, since a door that arrives with the wrong handing or a misplaced bore hole is your problem to reorder, not the supplier’s.
Stage 3: Day-one demo and prep (2 to 4 hours). We pull the old unit, inspect the framing and sill for rot or water damage, and repair what’s soft before anything new goes in. The rough opening gets cleaned, shimmed, and checked for level. Any rot at the threshold or jamb gets addressed here, not covered up.
Stage 4: Setting and sealing the unit (2 to 3 hours). The door goes into the opening, gets shimmed and plumbed, and the fasteners go in. We flash and seal the exterior perimeter, then fit hinges, strike plates, lockset, and deadbolt. On exterior doors in bay-facing homes, we pay attention to the bottom seal, since wind-driven rain is the most common source of the water issues we see.
Stage 5: Trim, hardware, and walkthrough (1 to 2 hours). Casing and interior trim go back on, the door gets its final adjustment for latch and swing, and we walk you through the operation, the finish schedule, and a short maintenance routine. Most single-door jobs close out in a single day once the door is on site. Multi-door projects spread across two to three days.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The door options you’ll choose between
A door is three decisions stacked on top of each other: what it’s made of, how it’s hung, and how it’s finished. Here’s how the choices actually trade off.
- Fiberglass entry doors. The most common pick for exterior doors in Emeryville because bay air and fog don’t damage them the way they damage steel. They take paint or stain well, hold insulation value, and resist denting. Therma-Tru is a solid example. Expect $1,200 to $2,800 installed for a standard size.
- Wood entry doors. Warm, repairable, and the right match for older bungalows and craftsman-style cottages. The trade-off is maintenance: annual sealing against the marine air, and a real risk of swelling at the bottom in wet winters. $1,500 to $3,200 installed for a quality solid-wood unit.
- Steel entry doors. The strongest and most secure option, and the cheapest of the three, but salt air and fog accelerate corrosion at any scratch or seam. Best suited to covered entries. $700 to $1,800 installed.
- Interior prehung doors. Hollow-core or solid-core, in a standard slab height. Prehung units are faster and cleaner than slab-and-frame work, which keeps labor down. $300 to $800 installed per door, depending on grade and hardware.
- Glazing and finish. A full-lite or sidelight adds light and cost, and frosted or Low-E glass runs higher again. Hardware finish is a small line item that makes an outsized difference to how the door feels a year later.
What Door Installation costs in Emeryville, CA
Most door installation in Emeryville lands between $650 and $3,200 per door, all-in. That includes removal, disposal, framing repairs, hardware, sealing, and trim. Five variables push a job toward the low or high end:
- Door type and material. Interior hollow-core prehung sits near $650 installed. A fiberglass or wood entry door with sidelights climbs past $2,800.
- Rough opening condition. A square, sound opening adds nothing. Rot at the sill or framing can add $200 to $600 in repair before the new door goes in.
- Size and configuration. A standard 36-inch single door is the baseline. Double doors, oversized units, and transoms multiply material and labor.
- Hardware and glass. A basic lockset is included in the quote. Multi-point locking systems, smart locks, and decorative glass run $150 to $600 extra.
- Permit scope. Interior door swaps generally don’t require a permit. Structural changes to an opening or exterior door replacement in certain conditions may, and permit costs get itemized separately in your written quote.
Every estimate we send is upfront pricing, no surprises: the number you see is the number you pay, with no change orders unless you approve a scope change in writing. Projects over $10,000 qualify for $1,000 off, and 0% financing for 18 months is available to spread the cost.
See the difference
Before
After
Before
After
Before
AfterWhat Emeryville homes specifically do to this job
Emeryville is a built-out city where almost every project is infill: former warehouse and industrial parcels converted to housing, biotech, or retail. That history shows up in door work more than you’d expect. In the early-1900s worker cottages and bungalows west of San Pablo Avenue and around Doyle Street, we routinely find rough openings that were never square, walls that have moved, and thresholds sitting a full inch out of level from a century of settling. The right response there isn’t to force-fit a stock door; it’s to true the opening first, which is why measurement matters more in Emeryville than in a 2005 subdivision. Anything near the shoreline adds another layer: foggy marine air accelerates corrosion on steel and exterior finishes, so hardware and finish choice matter more than they would five miles inland. And on the flat, low-lying parcels close to the bay, rain season from November through March dictates sequencing, since exterior door sealing has to happen on a dry day. If the door is part of a full Windows & Doors in Emeryville scope, we plan the whole envelope together. Our Windows & Doors service covers the full range of that work, and we handle jobs across Emeryville and the neighboring cities.
Serving Emeryville, CA – Our Local Coverage Area
We serve Emeryville and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently asked: Door Installation in Emeryville
Most single-door installations are completed in one day, once the door is on site. Interior prehung doors take two to four hours; exterior entry doors with framing or sill repair run six to eight hours. Custom orders add three to four weeks of lead time before the install date. Call (833) 997-7759 for a schedule that fits your project timeline.
Interior door replacement generally doesn’t require a permit. Exterior door replacement without structural changes is often exempt as well, but the answer depends on whether the opening is being resized or the wall altered. We confirm permit scope during the estimate and list it as a separate line item if one is needed. Call (833) 997-7759 with your address and we’ll tell you exactly what applies.
Yes, in most cases. A straight like-for-like replacement keeps existing openings, wiring, and framing untouched. Moving a door to a new location, widening an opening, or converting a closet door to a standard swing may require framing changes and, in some cases, a permit. We flag that during the site visit so there are no surprises later. Call (833) 997-7759 for a free on-site measurement.
Door installation in Emeryville ranges from $650 for a standard interior prehung door to $3,200 for a custom wood or fiberglass entry with sidelights. The biggest cost drivers are material choice, opening condition, and hardware grade. Every quote is itemized line by line, so you see exactly what drives the number. Call (833) 997-7759 for an exact quote; estimates are free.
All door installation work is backed by our 730-Day Done Right Promise: if it’s not done right, we make it right. Labor and workmanship are covered for the full two-year period, and the door manufacturer’s warranty covers the unit itself. Calls are answered by a live person around the clock, so a question about a door that’s sticking in month six doesn’t wait until Monday.
Schedule your free Door Installation estimate in Emeryville
Replacing a tired door or fitting out a converted cottage? We’ll come out, measure the opening, walk you through the material and hardware choices, and hand you a written line-item estimate with a fixed number and a realistic timeline. Infill parcels, converted industrial buildings, and century-old bungalows are all part of the work here. Call (833) 997-7759 to schedule your free on-site estimate.
Written by the team at Groundwork Construction Co.