Kitchen remodeling
Bathroom remodeling
Home additions & ADU
Roofing
Windows & doors
Driveway & pavers
FenceFree written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Window Installation in San Francisco, CA: What It Takes and What It Costs
Window installation in San Francisco typically runs $5,310 to $17,700 for a whole-home replacement scope, and a single opening usually lands in the $900 to $2,600 range once the framing is sound and the permit is straightforward. Most jobs we quote here take one to three working days for the actual installation, with two to six weeks ahead of that for ordering and city permits. Call (833) 997-7759 and a live person will pick up, any hour, to start a free on-site estimate.
How the Job Actually Goes, Day by Day
Window installation on a San Francisco Victorian is not a swap-and-caulk job. The walls are thick, the framing is often rough-cut old-growth lumber, and the exterior trim has to match a façade the city keeps an eye on. Here is the real sequence.
Stage 1: Site walk and measuring (about 60 to 90 minutes)
We measure every opening at three points (top, middle, bottom) because old frames in 1880s – 1920s buildings are rarely square. We also open up a couple of interior trims to see what the rough framing looks like behind the plaster. You decide here whether you’re keeping the existing trim profile or going new, which is the first real fork in the road.
Stage 2: Ordering and permitting (two to six weeks)
Units go to our brand partners (ECO Window Systems and ViewLux are common picks on our San Francisco work), and lead times run three to five weeks for standard sizes, longer for anything custom. If your home sits in a historic-review zone, the city’s review can add weeks on its own. We pull the permits and hand you the line-item cost before anything is ordered.
Stage 3: Day-one prep and demo (one day for most homes)
We lay drop cloths, pull the old sashes and stops, and inspect the rough opening. This is where surprises surface: dry rot at the sill, a header that needs sistering, or a wall cavity that’s been holding moisture for years. We photograph anything unexpected and call you before doing the fix.
Stage 4: Setting and sealing the units (one to two days)
New units are shimmed, plumbed, and fastened, then flashed and sealed at the exterior. Fog-cooled San Francisco winters mean any moisture intrusion at the sill becomes a rot problem fast, so the flashing detail gets more attention here than in a drier climate. Insulation goes in around each frame before interior trim closes it up.
Stage 5: Trim, finish, and inspection (one day plus the city visit)
Interior and exterior trim go back on, we touch up paint, and the city inspector signs off. You walk the job with us unit by unit. Every installation is backed by the 730-Day Done Right Promise, which means if a seal fails or a unit shifts, we make it right.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The Options You’ll Be Choosing Between
Window installation comes down to four decisions, and each one moves the price in a predictable direction.
- Frame material: Vinyl is the value pick and holds up well against coastal fog, but the color palette is limited. Wood-clad aluminum (Andersen and Marvin both make it) gives you a true painted finish that fits a Victorian façade; expect it to land 30 to 50 percent above vinyl.
- Glass package: Double-pane is the baseline. Low-E coatings help with heat loss, and laminated glass adds security and sound deadening, which matters on Mission District streets where traffic noise carries.
- Operating style: Double-hung is the period-correct choice for most San Francisco Victorians. Casement and awning windows seal tighter and swing outward, which can be a problem on narrow lots with close-set neighboring walls.
- Trim and finish: Reusing the original interior casing saves money and keeps the historic look. New matching trim runs higher because each profile has to be fabricated to match.
If your project widens to include a front door or a patio slider, that work is a separate scope and lives on our Windows & Doors in San Francisco page.
What Window Installation Costs in San Francisco, CA
Whole-home window installation in San Francisco runs $5,310 to $17,700. For a single opening, plan on $900 to $2,600 depending on size and material.
| Line item | Typical range |
|---|---|
| Single vinyl double-hung unit, installed | $900 – $1,600 |
| Single wood-clad unit, installed | $1,400 – $2,600 |
| Whole-home install, 8 to 12 units | $5,310 – $17,700 |
| Impact-rated units (where required) | $9,440 – $29,500 |
What pushes a job to the high end: dry rot at the rough opening, header repair, matching a historic trim profile, or a custom size that needs fabrication. What keeps it low: sound framing, standard sizes, and a straightforward permit. Your written estimate lists every unit, the labor, the permit fee, and the disposal separately. We call before adding anything mid-job. Existing promotions: $1,000 off projects over $10,000, 0% financing for 18 months, and a free design consult.
See the difference
Before
After
Before
After
Before
AfterWhat San Francisco Homes Specifically Do to This Job
Most of the window installation work we do in San Francisco happens on 1880s – 1920s wood-frame Victorians and Edwardians packed shoulder-to-shoulder on narrow lots. In the Mission and Noe Valley, the framing is real and the plaster is deep, but the exterior trim is often original and needs a careful hand. Out in the avenues and ZIP codes 94151 and 94159, the stock is a touch newer but the coastal moisture still drives rot at every sill. The city’s seismic retrofit rules for soft-story buildings mean we check structural bracing before we ever set a window, since a unit framed into a wall that’s about to be reinforced will have to come out. And the planning department’s historic-review triggers can add weeks to a permit that in Daly City or South San Francisco would be a same-week turnaround. We quote and build to that timeline before we take a deposit.
If your home improvement list runs long, homeowners often pair this with Wood Fence in San Francisco or Chain Link Fence in San Francisco to finish the yard at the same time.
Serving San Francisco, CA – Our Local Coverage Area
We serve San Francisco and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked: Window Installation in San Francisco
Most jobs take one to three working days on-site. The bigger variable is the lead time before that, which is three to five weeks for ordering plus however long the permit takes, and in historic-review zones that can add several more weeks. Call (833) 997-7759 for a timeline built around your home, not a generic estimate.
Yes, almost always. The city requires a permit for any window replacement that changes the opening or the exterior profile, and historic-district properties may need planning review first. We pull the permit and schedule the inspection as part of the job.
Yes, in most cases. Window installation rarely touches plumbing or interior structure unless a unit is being enlarged. If the rough opening needs sistering or a header needs repair, we flag it during the site walk before any work begins.
Whole-home runs $5,310 to $17,700; a single opening lands around $900 to $2,600. The number hinges on material, size, and how much rot shows up when we open the wall. Call (833) 997-7759 for an exact quote on your home.
Every installation is covered by our 730-Day Done Right Promise, which means if something we installed isn’t right, we make it right. Manufacturer warranties on the units themselves stack on top of that.
Get a Free Estimate for Window Installation in San Francisco
When you call (833) 997-7759, a live person answers, day or night, and schedules a free on-site estimate at your home. We measure, check the framing, and hand you a written line-item quote with the permit and disposal included. No pressure, no vague numbers. That’s our Windows & Doors service, and the full San Francisco area page covers what else we handle here.
Written by the team at Groundwork Construction Co.