Kitchen remodeling
Bathroom remodeling
Home additions & ADU
Roofing
Windows & doors
Driveway & pavers
FenceFree written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Door Installation in South San Francisco, CA: What It Takes and What It Costs
Door installation in South San Francisco usually means a single exterior or interior door swapped out in one day, while entry-door replacements with new framing, hardware, and a security deadbolt run about $950 to $3,400 depending on material and whether the rough opening needs work. We handle the whole job – measuring, permit check, removal, framing adjustments, and finish – for homes in the 94080 and 94083 ZIP codes. Call (833) 997-7759 to set up a free on-site estimate, and we’ll give you a written line-item quote before anyone touches a hinge.
How our Door Installation Process Works, Start to Finish
Most of the doors we install in South San Francisco go in over two visits: a measuring and prep day, then the installation day. Larger entry systems with sidelites or new framing can stretch to three. Here’s what actually happens.
Day 1 – Measure and scope. A technician checks the rough opening, the existing jamb, and the sill for rot or settling. On the older flatland homes west of the 101, we regularly find that a door that looks plumb is sitting in a frame that’s out of square by a quarter inch or more. We note whether the opening needs to be rebuilt or just adjusted. You decide the door material and hardware options at the end of this visit. This takes 45 to 90 minutes.
Day 2 (or 3) – Removal and prep. The old door comes out, and we inspect the framing and threshold for water damage, especially on windward-facing entries where fog-belt moisture has been working on the sill for years. Rotted sill plates get replaced before the new unit goes in. Prep and dry-fit take half a day.
Installation. The new door is set, shimmed, and checked for square, then anchored and flashed at the exterior. We test the swing and latch before we close anything up. This is where a defective unit or a bad measurement shows itself – we catch it here, not after the trim is on. Roughly 3 to 5 hours for a standard door.
Hardware and security. Deadbolts, handlesets, and – if you chose one – a smart lock or rolling-code opener get installed and tested with you present. On South San Francisco townhomes and alley-load garages, this is often the part homeowners care about most.
Finish and walkthrough. Casing, trim, caulk, and paint touch-up. We walk the job with you, demonstrate the lock and any electronics, and hand over the warranty paperwork for the 730-Day Done Right Promise. A clean single-door job is done in one working day once we’re past the measuring stage.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The Door Options You’ll Actually Choose Between
The material and hardware choices drive both the price and how the door holds up in South San Francisco’s damp, windy climate. Here’s the honest rundown.
- Fiberglass entry doors (Therma-Tru and similar): The best fit for fog-belt conditions. They don’t swell or warp with moisture the way wood does, they hold paint and stain well, and they insulate better than steel. Higher upfront cost than wood but fewer callbacks five years out.
- Steel doors: Strong, secure, and the most affordable for a solid entry. The trade-off is that dents don’t come out and the finish can chip at the bottom edge where wind-driven rain hits. Good for a back or side door, less ideal for the main entry facing the weather.
- Solid wood: Beautiful and repairable, but it moves with humidity. In a cool coastal climate with persistent onshore wind, an under-protected wood door will need refinishing every few years. It suits a covered entry far better than an exposed one.
- Interior doors (hollow or solid core): Hollow-core keeps the cost down for closets and bedrooms. Solid-core cuts sound transfer, which matters in the denser townhome and infill builds along El Camino Real.
- Security hardware: Grade-1 deadbolts, reinforced strike plates, and rolling-code or smart-lock remotes. On townhomes with shared alley access, upgraded locking hardware is the upgrade most worth the money.
We carry brand partners including Therma-Tru and ECO Window Systems so you’re choosing on quality, not just what’s on the shelf. Tell us how the door gets used and we’ll steer you to the right grade.
What Door Installation Costs in South San Francisco, CA
Plan on $450 to $1,200 for a standard interior door installed, $950 to $2,600 for a fiberglass or steel exterior door, and $2,000 to $3,400 for a full entry system with sidelites, new framing, and upgraded security hardware. These are installed prices, not just the door.
| Scope | Typical Installed Range |
|---|---|
| Interior door (single) | $450 – $1,200 |
| Exterior door, standard | $950 – $2,600 |
| Entry system w/ sidelites + framing | $2,000 – $3,400 |
| Security hardware / smart lock add-on | $150 – $600 |
What pushes a job to the high end: a rough opening that’s out of square or rotted (common in the pre-war and mid-century homes here), a door that needs new framing, upgraded security hardware, or an entry system with sidelites. What keeps it low: a straightforward swap into a sound existing frame with standard hardware. Every written estimate lists materials, labor, disposal, and permit costs as separate lines – the number you see is the number you pay, no change orders after the fact. What’s not included unless we scope it: structural repair beyond the frame, painting the surrounding wall, and any electrical work for a wired smart lock, which we quote separately.
See the difference
Before
After
Before
After
Before
AfterWhat South San Francisco Homes Specifically Do to This Job
South San Francisco is the Industrial City, and that shapes residential work in ways a Peninsula contractor from a few miles south won’t expect. Much of the older housing on the flatlands west of Highway 101 is pre-war or mid-century, and a lot of it carries knob-and-tube wiring and unpermitted additions. When we pull a door and find a jamb pocketed into framing that was never inspected, we slow down and check the header before we install anything. The fog-belt climate just south of San Francisco also matters: cool, damp summers and persistent onshore winds push moisture into windward-facing thresholds, so we flash and seal exterior doors more aggressively here than we would in the sunnier towns to the south. Permit requirements for a door replacement in the 94080 ZIP are typically light if you’re keeping the same opening size, but a new rough opening or a change to the entry configuration usually triggers a review – we confirm which applies before we quote, and we handle the paperwork. On the denser townhome and infill projects along El Camino Real, alley-load entries and tight side-yard clearances mean we work around parking and access, often scheduling delivery and staging to fit a short driveway or shared carport.
Serving South San Francisco, CA – Our Local Coverage Area
We serve South San Francisco and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked – Door Installation in South San Francisco
A single door is usually installed in one working day, with measuring and prep adding a partial day before it. Entry systems with sidelites or new framing can take two to three days. Call (833) 997-7759 to get a timeline for your specific door.
A straight replacement into the same opening usually doesn’t need a permit, but a new rough opening or a change to the entry configuration generally does. We confirm which applies to your door during the free estimate and pull any required permits ourselves.
In most cases, yes. A door replacement keeps the existing opening and frame unless we find rot or out-of-square framing that has to be repaired. When structural work is needed, we scope it in writing before starting.
Interior doors run $450 to $1,200 installed, exterior doors $950 to $2,600, and full entry systems with sidelites and framing $2,000 to $3,400. Call (833) 997-7759 for an exact quote – estimates are free.
Every door we install is covered by our 730-Day Done Right Promise – if it’s not done right, we make it right. If a door sticks, leaks, or fails to latch within that window, we come back and fix it.
Get a Free Door Installation Estimate in South San Francisco
A new door is often the first step in a larger exterior update – many homeowners pair it with a full Windows & Doors in South San Francisco project, or add a Chain Link Fence in South San Francisco or a Vinyl Fence in South San Francisco at the same time. We cover all of South San Francisco and the surrounding area through our Windows & Doors service. Call (833) 997-7759 for a free on-site estimate – a live person answers around the clock, and we’ll walk your opening, confirm the material, and hand you a written line-item quote.
Written by the team at Groundwork Construction Co.