Roofing
Kitchen remodeling
Bathroom remodeling
Home additions & ADU
Windows & doors
Driveway & pavers
FenceFree written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Metal Roofing in San Pablo, CA: What It Costs and What It Takes
Metal roofing in San Pablo, CA runs $15,000 – $40,000 installed, and most homes here take four to seven working days once the material is on site. That price buys a wind-rated standing-seam or exposed-fastener system over new underlayment, not a cover-over. Call (833) 997-7759 and we’ll walk your roofline with you and put a line-item number in writing before anything is ordered.
How We Install Metal Roofing, Stage by Stage
Metal doesn’t go on like shingle. The prep work decides whether the panel ever rattles, lifts or leaks, so the first two days are mostly tear-off and inspection.
Stage 1: Tear-off and deck inspection (1 – 2 days)
We strip the existing roof to the sheathing and walk every sheet. On San Pablo’s post-WWII homes this is where we find the soft spots, because salt air and winter rain have been working behind sound-looking stucco for decades. You get photos of anything we find and a decision to make before we go further.
Stage 2: Deck repair and flashing rebuild (1 – 2 days)
Rotten sheathing gets replaced, not covered. We rebuild the valleys, penetrations and wall flashings in metal rather than reusing tired ones, which is the single biggest factor in a metal roof lasting its full life. If framing repair is needed, that’s a change you approve in writing before we touch it.
Stage 3: Underlayment and wind-rated attachment (1 day)
We roll a high-temp synthetic underlayment and fasten it with the same uplift rating the panels will carry. Fastener pattern and spacing get set here to the wind rating on the permit. You’ll usually pick your panel color and profile before this day so material is on site.
Stage 4: Panel install and trim (2 – 3 days)
Panels go down in order, flanked by gable trim, ridge cap and eave closure. This is where craft shows: straight lines, tight seams, no oil-canning across the flats. Standing seam panels are rolled or pre-formed to your run lengths, so fewer end laps.
Stage 5: Inspection and final walk (same day)
We call for the inspection, walk the finished roof with you, and hand over the manufacturer paperwork. Anything on the punch list gets handled under our 730-Day Done Right Promise – if it’s not done right, we make it right.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The Metal Roofing Options You’ll Choose Between
Landing on metal is step one. The job itself comes down to four or five spec calls, and each one moves the number.
- Standing seam vs. exposed fastener: Standing seam hides the fasteners under raised ribs and carries the tighter wind rating; exposed-fastener panels cost less but rely on hundreds of screws and washers that eventually need tightening in salt air. For San Pablo’s bay-corridor wind, standing seam is usually the better long game.
- Steel vs. aluminum: Steel is stronger and cheaper per panel; aluminum resists corrosion better, which matters close to the shoreline. Most homes here do fine with a quality coated steel, and aluminum makes sense on the most exposed bayside slopes.
- Finish and color: A factory finish with a real warranty beats a field-painted look every time. Lighter colors cut heat gain and hide the salt film that builds on darker panels.
- Panel profile and gauge: Heavier gauge holds up to wind and foot traffic better. The savings on a thin panel rarely pay back in this climate.
- Trim and accessory package: Ridge venting, snow guards if you want them, and gutter integration all get priced here. Skipping them is a false economy.
If the roof is part of a bigger exterior plan, homeowners often pair this with Impact Windows & Doors in San Pablo so the whole envelope carries the same wind rating.
What Metal Roofing Costs in San Pablo, CA
Expect $15,000 – $40,000 for a full metal roof in San Pablo, CA. A simple single-story hip roof on a modest lot lands near the bottom; a steep, cut-up roof with valleys and dormers on a larger home pushes toward the top.
Here’s what moves the number:
- Roof size and pitch: Square footage times pitch drives panel count and labor. Steep roofs need more staging and caution.
- Deck condition: Rotten sheathing or framing found at tear-off adds cost. On San Pablo’s older stucco homes this is the most common surprise.
- Panel type: Standing seam and heavier gauge sit at the high end; exposed-fastener panels sit lower.
- Roof complexity: Valleys, dormers, skylights and multiple penetrations each add flashing time.
- Permit scope: A straightforward re-roof permit is one thing; anything that touches structure or fire rating is another.
Our written estimate lists tear-off, deck repair allowance, underlayment, panels, trim and permit line by line, so the number you see is the number you pay. Expect a free on-site estimate and a written quote within a few days.
See the difference
Before
After
Before
After
Before
AfterWhat San Pablo Homes Specifically Do to This Job
San Pablo is an older, densely built city on the Richmond shoreline, much of it mid-century stucco-over-wood-frame on small lots. The housing stock is largely post-WWII to 1960s single-story homes, with pockets of older cottages and mid-century apartments, and nearly every metal roof job here starts with the same reality: the roofline hides damage.
The fog-cooled, windy San Pablo Bay corridor is the reason. Salt-laden marine air eats wood trim and speeds corrosion on fasteners, and winter rain finds every failed flashing. On homes along the bay-facing slopes and the low-lying flats near San Pablo Creek, crews routinely find dry rot on the exposed side and moisture pooling in crawl spaces, hidden behind stucco that looks fine. That’s why a metal roof install here is really a wind-load and weatherproofing job, not just a shingle swap.
Permitting runs through Contra Costa County, and older, often non-conforming lot lines mean setbacks and inspection access need sorting early. We’re careful to confirm the wind rating on the permit before panels go up. We cover the whole city, from the flats up the slopes; see our San Pablo service page for how we work locally.
Serving San Pablo, CA – Our Local Coverage Area
We serve San Pablo and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked Questions About Metal Roofing in San Pablo
Most metal roofing jobs run four to seven working days on site once material arrives, with ordering adding a few weeks. Larger or more complex roofs take longer, and deck repair found at tear-off can add a day or two.
Yes. A metal roof needs a permit through Contra Costa County, and the wind rating gets confirmed before panels go up. We handle pulling the permit and scheduling the inspection as part of the job.
Usually, yes. In most cases we re-roof right over the same sheathing and don’t touch plumbing or structure unless tear-off reveals rotten framing. Anything structural is priced and approved in writing first.
Full metal roof installation runs $15,000 – $40,000 here, depending on size, pitch, panel type and deck condition. Call (833) 997-7759 for an exact quote – estimates are free.
You get the manufacturer’s material warranty plus our 730-Day Done Right Promise on the workmanship. If something isn’t right, we come back and make it right.
Get a Free Metal Roofing Estimate in San Pablo
If you’re weighing a metal roof, the fastest way to a real number is a free on-site estimate. Call (833) 997-7759 and we’ll set a time, walk your roof, check the deck and flashing, and hand you a line-item written quote. No pressure, no guesswork, just a clear number you can budget against.
Written by the team at Groundwork Construction Co.