Windows & doors
Kitchen remodeling
Bathroom remodeling
Home additions & ADU
Roofing
Driveway & pavers
FenceFree written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Sliding & Patio Doors in San Francisco, CA: What the Job Actually Involves
Replacing a sliding patio door in San Francisco typically runs $3,200 to $9,800 installed, and most single-door swaps take one to two days once the permit clears. The work means pulling the old slider, checking the header and framing for rot, and setting a new door that seals tight against fog and driven rain. Sliding & Patio Doors sit in an exterior wall, so this is framing and waterproofing work as much as it is glass. Call (833) 997-7759 for a free on-site estimate.
How We Do This Job, Start to Finish
Sliding & Patio Doors fail in predictable ways, and the repair sequence follows those failures. Here’s the real order of work and what you’ll be deciding along the way.
Stage 1: Measure and assess the opening (day 1, about 90 minutes)
We measure the rough opening, check the sill for level, and probe the framing around the door for soft wood. In older San Francisco Victorians and Edwardians, an aluminum slider from the 1970s or 1980s often sits in a wall where the header has sagged a little. We note whether the framing is sound, whether the threshold is letting water track back into the wall, and whether the opening is square enough to accept a standard unit. You decide the door material and configuration after this visit, not before.
Stage 2: Pull the permit and order the unit (days 2 to 10)
Exterior door replacement in San Francisco is permitted work under the California building code, and the timeline depends on the city’s review queue. Once the permit is issued, we order the door. Stock sizes from ECO Window Systems or Mr-Glass move in a week or two; custom widths for a non-standard Victorian opening can run four to six weeks. You’ll pick glass package, frame color, and screen options at this point.
Stage 3: Demo and prep (day of install, first 2 to 3 hours)
We pull the old slider, vacuum out the track debris, and inspect the rough opening. Any rotted sill plate, sheathing, or subfloor edge gets replaced before the new unit goes in. This is the step most quick-turn installers skip, and it’s the reason cheap door jobs leak within two years on the fog belt.
Stage 4: Set, shim, flash, and seal (day of install, next 3 to 4 hours)
The new door gets set plumb, shimmed at the hinge side and sill, and flashed with self-adhering membrane before trim goes back on. We seal the exterior with a proper backer rod and sealant joint rather than a smear of caulk. The unit is checked for square and for smooth operation across the full travel of the panel.
Stage 5: Inspect and finish (same day or next morning)
We test the lock, roller tension, and weatherstripping, then walk the inspection with you. The city inspector signs off on the permit after the install. Interior trim and paint touch-ups close out the job. You’ll have a written record of what was done and the 730-Day Done Right Promise behind the work.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
What You’ll Choose Between: Materials and Configurations
Sliding & Patio Doors come in a handful of real choices, and each one trades cost against how it holds up in San Francisco’s salt air and damp winters. Here are the options we walk homeowners through.
- Vinyl sliding doors: the budget-friendly choice, typically $2,800 to $5,500 installed. They don’t rot or need paint, but the frames can warp over time in direct sun and the color palette is limited. Good fit for a rental unit or a back door that doesn’t face the street.
- Fiberglass sliding doors (Therma-Tru, for example): $4,200 to $7,800 installed. Holds paint well, resists dents, and holds up to coastal moisture without the maintenance of wood. This is our most common pick for a primary exterior door in San Francisco.
- Aluminum sliding doors: $3,500 to $6,500 installed. Slim sightlines, strong frames, and low maintenance. Older aluminum sliders were the weak point in thousands of homes here; modern thermally broken units are a different animal.
- Wood-clad or full wood sliders (ViewLux as one option): $6,500 to $11,000+ installed. Beautiful and appropriate for a period Victorian, but the interior wood needs regular attention and the exterior wood must be kept sealed against the fog.
- Glass package: double-pane low-E is standard; triple-pane or laminated impact glazing adds $800 to $2,500 per door. Worth the upgrade on a door facing heavy weather or a busy street.
- Configuration: two-panel slider, three-panel, or a multi-slide pocket door system. Multi-slide systems run $9,000 to $20,000+ installed and often need a wider opening and a structural review.
What Sliding & Patio Doors Cost in San Francisco, CA
Most single-door replacements land between $3,200 and $9,800 installed, with multi-slide systems and period-appropriate wood units pushing higher. Here’s what moves the number.
| Item | Typical Range (Installed) |
|---|---|
| Standard two-panel vinyl slider | $2,800 – $5,500 |
| Fiberglass or thermally broken aluminum slider | $4,200 – $7,800 |
| Wood-clad or full wood slider | $6,500 – $11,000+ |
| Impact or laminated glass upgrade | $800 – $2,500 add-on |
| Multi-slide pocket door system | $9,000 – $20,000+ |
| Rotted sill or framing repair | $400 – $1,800 add-on |
What pushes a job to the high end: enlarging the opening (structural header work, $2,000 to $6,000), relocating the door entirely, custom widths for a non-standard Victorian opening, and finish upgrades on the interior trim. What keeps it low: a standard stock size in a sound opening with a straightforward permit. Every estimate we write is line-item and fixed; the number you see is the number you pay. The 0% financing for 18 months and $1,000 off projects over $10,000 help on multi-door jobs. Call (833) 997-7759 for a written quote.
See the difference
Before
After
Before
After
Before
AfterWhat San Francisco Homes Specifically Do to This Job
San Francisco’s housing stock is the reason this job is never routine here. The city has the densest concentration of pre-1906 wood-frame Victorians and Edwardians in the country, packed shoulder-to-shoulder on narrow lots, and most sliding doors we replace sit in an opening that’s slightly out of square or has a sill that’s been quietly absorbing fog-moisture for decades. The damp winters and cool summers mean the wall around a door stays wet longer than it would in a hotter climate, so rot in the sill and the sheathing below it is common and often hidden until the old unit comes out. Working on a Noe Valley or Mission Victorian, we plan around the Planning Department’s historic-review triggers if the door faces a street; a rear-yard door onto a patio usually avoids that. Silicon Valley is a different market; here a simple door swap can turn into a structural header conversation once the wallboard comes off. If the wider job calls for it, this work often fits into a full Windows & Doors in San Francisco project, or into our windows & doors service across the city.
Serving San Francisco, CA – Our Local Coverage Area
We serve San Francisco and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked – Sliding & Patio Doors in San Francisco
Most single-door replacements take one to two days of install time, plus a permit review period of one to several weeks before we start. Stock sizes move fastest. Call (833) 997-7759 for a scheduling estimate on your specific door.
Yes. Exterior door replacement is permitted work under the California building code, and the install is inspected. We pull the permit and manage the inspection; we don’t hand you the paperwork and walk away. Ask us about the permit scope for your address when you call.
In most cases yes. If the opening is sound and close to a stock size, we set the new door in the existing frame. Widening the opening for a multi-slide system or a bigger unit is a structural change and adds $2,000 to $6,000. We tell you which you have after the first visit.
Plan on $3,200 to $9,800 installed for a standard single door, with wood-clad units and multi-slide systems higher. Rotted sill repair adds $400 to $1,800 if we find it. Call (833) 997-7759 for an exact line-item quote; estimates are free.
Every install is covered by our 730-Day Done Right Promise: if it’s not done right, we make it right. The door unit itself also carries the manufacturer’s warranty, which we hand you in writing. Call (833) 997-7759 with any warranty question on a job we’ve done.
Get a Free Sliding & Patio Doors Estimate in San Francisco
We come out, measure the opening, probe the framing, and leave you with a written line-item estimate for Sliding & Patio Doors before you commit to anything. You’ll know the door cost, the install cost, and the permit cost, all separated. Call (833) 997-7759 and a live person answers around the clock. Estimates are free, and the 730-Day Done Right Promise backs the work.
Written by the team at Groundwork Construction Co.