Kitchen remodeling
Bathroom remodeling
Home additions & ADU
Roofing
Windows & doors
Driveway & pavers
FenceFree written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Tub-to-Shower Conversion in Albany, CA: What It Costs and How Long It Takes
A tub-to-shower conversion in Albany typically runs $3,500 – $10,000 and takes 5 to 10 working days from demo to final inspection, depending on whether the drain and valve stay put or move. The job means pulling the tub, rebuilding the wet wall and pan, waterproofing properly, setting new tile or a surround, and getting it inspected. Call (833) 997-7759 for a free on-site estimate with a written, line-item quote.
How We Run a Tub-to-Shower Conversion, Stage by Stage
Most contractors treat this as a weekend swap. It isn’t. Here’s the real sequence, and where you make decisions along the way.
Stage 1: Measure and plan (day 1, about 90 minutes)
We measure the alcove, check the drain location and valve height, and confirm what’s behind the wall. In Albany’s older bungalows that means opening a small inspection cut to see whether the framing is sound and whether the existing valve is a modern pressure-balance unit or an old two-handle setup. You decide the shower footprint here: standard 60-inch alcove, a slightly wider custom pan, or a curbless entry if the floor structure allows it. This is also when we confirm whether the current drain is centered or offset, because that single fact drives the rest of the budget.
Stage 2: Demo and rough-in (days 2 – 3)
We pull the tub, remove the surround down to studs, and haul it out. Then the rough plumbing and electrical work: new drain and P-trap if the old tub drain is undersized or corroded, valve replacement, and a dedicated exhaust fan if the bathroom doesn’t have one. If the valve stays and the drain lines up, you skip most of the plumbing cost. If anything moves, this is the stage where the number changes, and we tell you before we touch a fitting, not after.
Stage 3: Framing, backer, and waterproofing (days 3 – 4)
New blocking for grab bars, cement backer board, and a bonded waterproofing membrane over the pan and walls. This is the stage nobody sees and the one that decides whether the shower lasts 30 years or leaks in three. We flood-test the pan for 24 hours before tile goes down. You don’t need to be there for it, but we document it.
Stage 4: Tile and finish (days 5 – 9)
Tile setting, grout, caulk at the changes of plane, then the glass, trim, niche, and fixtures. You’ve already picked your tile and finish at the estimate, so this stage doesn’t stall waiting on a decision. Most jobs add two to three days here if you choose a complex pattern or large-format slab walls.
Stage 5: Inspection and walkthrough (final day)
We call for the plumbing and building inspection, correct anything the inspector flags the same visit, and walk you through the finished shower: how the drain sits, how the door swings, where the shutoffs are. Then we leave the 730-Day Done Right Promise in writing. If a tile cracks, a seal fails, or the pan weeps, we come back and make it right.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The Options You’ll Choose Between
Most of the price spread on a tub-to-shower conversion in Albany comes down to five decisions. Here’s the honest trade-off on each.
- Acrylic or fiberglass surround ($3,500 – $5,500 total): Fast, watertight, easy to clean, and finished in two to three days. It looks like a hotel shower, not a custom one, and the seams eventually show wear. Good fit if you’re converting a rental or a guest bath and want durability without a tile budget.
- Ceramic or porcelain tile ($5,000 – $8,000 total): The middle path. Real tile, real grout lines, and 20-plus years of service if the pan is built right. Standard 12×24 porcelain runs cheaper than mosaics; small hex tile on the floor adds labor because there’s more cutting and more grout to seal.
- Large-format or slab tile ($7,500 – $10,000 total): Fewer grout lines, a cleaner look, and heavier material that needs a properly framed wall. Worth it if you’re pairing the shower with a full bathroom remodel and want the finishes to match across the room.
- Drain position: A centered drain that lines up with the existing tub drain is the cheapest build. Moving the drain to the center of a wider pan adds a few hundred dollars in plumbing and a poured or pre-sloped pan. A linear drain saves a curb step but costs more in materials and labor.
- Glass and door: A frameless glass panel and door adds $800 – $2,000 over a framed unit. It reads as a bigger bathroom, but it’s also a heavier install that needs solid backing behind the tile.
We source tile and fixtures through brand partners we’ve vetted for the category. Kohler for valves and trim is a common pick on these conversions because the cartridges are easy to service later. KraftMaid and Wellborn vanities come up when homeowners pair the shower with a new vanity at the same time. We don’t stock any of it, but we specify what fits the job and order it before demo starts so nothing stalls.
What Tub-to-Shower Conversion Costs in Albany, CA
The range for this job in Albany is $3,500 – $10,000, with most conversions landing between $5,000 and $8,000. Where you land depends on five things:
- Size of the alcove. A standard 60-inch tub replacement is the baseline. A wider custom pan or a walk-in with a bench pushes the framing and tile cost up.
- Existing condition. If the wall behind the tub has rot, old galvanized plumbing, or a rusted tub drain, that’s real repair money. In Albany’s older housing stock this is a coin flip until we open the wall.
- Plumbing and electrical moves. Keeping the valve and drain where they are saves several hundred dollars. Moving either one, or adding an exhaust fan where none exists, adds to the ticket.
- Material grade. Acrylic surround at the bottom of the range, tile in the middle, slab tile and frameless glass at the top.
- Permit and inspection scope. A plumbing permit plus a building permit adds a few hundred dollars in fees and inspection time. We pull the permits and pass the inspections, and it’s included in the written quote.
Your written estimate is line-item: demo, rough-in, waterproofing, tile, glass, permit fees, and a schedule. Pricing is upfront, no surprises. If we find rot or old wiring once the wall is open, we stop, show you, and quote the fix before we continue. There’s no change-order ambush. Work over $10,000 qualifies for $1,000 off, and 0% financing for 18 months is available on any project size.
See the difference
Before
After
Before
After
Before
AfterWhat Albany Homes Specifically Do to This Job
Albany is a small, fully built-out East Bay city, which means almost every tub-to-shower conversion here is a remodel inside a 1920s – 1950s wood-frame bungalow or a Mediterranean-revival stucco cottage, not new construction. That changes the job in ways you don’t see in newer suburbs. Behind the old tile you’ll often find knob-and-tube or early cloth wiring, which has to be brought up to code once we open the wall. The shallow pier-and-beam foundations mean plumbing runs are short and accessible through the crawlspace, which helps, but it also means a rusted cast-iron or galvanized drain is common once we start looking.
Permitting runs through a small city hall rather than a county department, so the sequence is tight: plumbing permit, building permit, inspection on the pan, final inspection. On the narrow lots near San Pablo Avenue and along the streets off Solano, a bathroom that was built out to within inches of the property line can trigger a setback or daylight-plane review before any framing happens, so we plan for that at the estimate, not after demo. The fog-cooled summers and wet winters also matter: exterior venting and any exterior tie-in to the shower fan gets scheduled inside a dry window, since the rainy season pushes exterior work.
If the shower is part of a larger project, homeowners often pair this with a Bathroom Remodeling in Albany scope or with Metal Roofing in Albany to fix the vent and moisture issues at the top of the house. We cover the whole city through our Albany service area, and our Bathroom Remodeling team coordinates with the shower crew so the schedule doesn’t slip. Some Albany homeowners also add Tile Roofing in Albany when the same rain exposure is causing leaks into the bathroom ceiling.
Serving Albany, CA – Our Local Coverage Area
We serve Albany and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked – Tub-to-Shower Conversion in Albany
Most tub-to-shower conversions take 5 to 10 working days, with the tile-and-finish stage accounting for the bulk of it. An acrylic surround version can finish in three to four days; a tile job with a moved drain and custom glass runs closer to the two-week end once inspection is scheduled. Call (833) 997-7759 for an exact timeline for your bathroom.
Yes, a plumbing permit and usually a building permit are required when you replace a tub with a shower. The permit covers the new drain, valve, waterproofing, and final inspection. We pull the permits and pass the inspections, and the fees are in your written quote. Call (833) 997-7759 and we’ll walk you through what your address needs.
Yes, and it saves money. If the drain and valve can stay where they are, most of the rough-in cost goes away and the job is faster. On Albany’s older homes we often find the tub drain is offset from the shower drain position, which is a cheap adjustment. The only way to know is to look. Call (833) 997-7759 to schedule a free on-site estimate.
Expect $3,500 – $10,000 for a tub-to-shower conversion in Albany, with most jobs landing in the $5,000 – $8,000 range. Acrylic surrounds sit at the low end, tile in the middle, and slab tile with frameless glass at the top. Call (833) 997-7759 for a free line-item estimate.
Every tub-to-shower conversion is covered by our 730-Day Done Right Promise, one of the longest workmanship guarantees in residential construction. If anything isn’t right, we come back and fix it, no fine print. Calls are answered by a live person 24/7. Call (833) 997-7759 to start.
Get a Free Estimate for Your Tub-to-Shower Conversion in Albany
Call (833) 997-7759 to schedule a free on-site estimate for your tub-to-shower conversion in Albany. We measure the alcove, check the drain and valve, look behind the wall, and hand you a written, line-item quote with a schedule and a fixed price. No surprises, no change-order ambush. Background-checked technicians, upfront pricing, and the 730-Day Done Right Promise in writing. Financing available.
Written by the team at Groundwork Construction Co.