Kitchen remodeling
Bathroom remodeling
Home additions & ADU
Roofing
Windows & doors
Driveway & pavers
FenceFree written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Tub-to-Shower Conversion in Foster City, CA: What the Job Actually Involves
A tub-to-shower conversion in Foster City runs $3,500 to $10,000 and typically takes 5 to 8 working days from demo to final inspection. The job means pulling the old tub, reworking the drain and valve to shower height, waterproofing the wet area, and setting a new shower base and walls. Most Foster City homes we work on were built between the 1960s and 1980s, which is exactly why the plumbing inside the wall often sets the real scope. Call (833) 997-7759 for a free on-site estimate before you commit to anything.
How a Tub-to-Shower Conversion Comes Together, Stage by Stage
This isn’t a swap. A tub and a shower use the same footprint but not the same rough-in, and the sequence matters more than the showroom choices. Here’s how the days actually break down.
Days 1 – 2: Demolition and what we find behind the wall
We protect the floor and adjacent rooms, then remove the tub, surround, and valve trim. On Foster City tract homes from this era, this is where the surprise usually lives: galvanized supply lines that have narrowed to a pencil-width inside, or a drain that was never sized for a shower’s higher flow. We open the wall enough to see the truth and photograph it for you. You decide, at this point, whether to replace just the valve or the whole supply run. That decision is the single biggest cost fork in the whole project.
Day 2 – 3: Rough plumbing and the permit inspection
The drain gets converted from tub depth to shower depth, the valve gets set at shower height (typically 42 to 48 inches to center), and we add blocking for grab bars whether or not you’re installing them now. A plumbing rough-in inspection happens here. On Foster City’s 1960s and 1970s homes, we often find the original cast-iron drain is still serviceable but the trap arm shows corrosion from decades of damp bay air moving through the crawlspace and wall cavities. You approve the rough-in scope before the wall closes.
Day 3 – 4: Waterproofing
This is the stage most homeowners never see and the one that decides whether the shower lasts 5 years or 25. We install a bonded waterproofing membrane over cement backer board, tape and seal every seam and corner, and flood-test the pan for a full 24 hours. You don’t have to make decisions here, but you should ask to see the flood test. A conversion that skips this step is the number one reason showers leak into the room below.
Day 5 – 7: Tile, glass, and trim
Tile goes up, then the shower base or tiled pan, then the valve trim and showerhead, then the glass. This is where your finish selections from weeks earlier become real. Grout cure adds a day before the shower sees water. We schedule the glass template measurement back on demo day so the enclosure is ready rather than adding a week of waiting.
Day 7 – 8: Final inspection and walkthrough
Final plumbing and building inspection, then a walkthrough where we run the shower, check every slope and drain, and hand over care instructions. Your selections need to be locked in by end of week one of the schedule, not at the tile stage. Picking tile after demo starts is the most common reason jobs stretch.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The Choices You’ll Actually Make (And What Each One Costs You)
Once the rough-in is settled, the rest of the tub-to-shower conversion is a series of trade-offs between cost, durability, and maintenance. Here’s what we walk Foster City homeowners through.
- Acrylic or fiberglass surround panels vs. tile. Panels run $1,200 – $2,800 installed and go in fast; they’re easy to clean and forgiving for a rental or a quick resale prep. Tile runs higher and takes longer but lasts decades and lets you match the rest of the bath. If you’re staying put, tile wins.
- Tiled shower pan vs. prefabricated base. A molded base is cheaper and leak-proof by design; a tiled pan lets you continue the floor tile through the shower and looks more custom, but demands a properly sloped and flood-tested pan. We build both; tiled pans are the more popular choice on higher-end Foster City jobs.
- Framed vs. frameless glass. Framed enclosures cost less and suit a tighter budget. Frameless glass (we frequently spec Mr-Glass for the enclosure hardware) opens up a small bathroom visually and cleans up easier, but you’re paying for thicker tempered glass and better hinges.
- Standard valve vs. thermostatic or pressure-balancing valve. A basic pressure-balancing valve is included in most budgets. A thermostatic valve adds control and cost but matters if you’ve got other fixtures running at the same time in a small Foster City bath.
- Grab bars, a bench, or a low curb. Aging-in-place features are best planned before the rough-in, not after. Blocking for bars adds almost nothing if done during stage 2; retrofitting it later means opening the wall again.
What Tub-to-Shower Conversion Costs in Foster City, CA
Budgets here land between $3,500 and $10,000, with most Foster City jobs we quote sitting in the $5,500 – $8,000 middle. The number is driven by five real variables, not “pricing varies.”
| Line item | Typical range |
|---|---|
| Demo and haul-away | $400 – $900 |
| Rough plumbing (drain + valve conversion) | $900 – $2,400 |
| Waterproofing and backer | $600 – $1,500 |
| Shower base or tiled pan | $500 – $1,800 |
| Wall finish (panel or tile) | $800 – $3,000 |
| Glass enclosure | $700 – $2,500 |
| Fixture trim, valve, showerhead | $300 – $1,200 |
| Permit and inspection fees | $200 – $600 |
The variables that push you toward $10,000: relocating the drain (which means opening the slab or subfloor), replacing galvanized supply lines, converting a tub-only valve to a thermostatic setup, upgrading to large-format tile or a frameless enclosure, and any structural work if the old tub alcove needs reframing. A straight swap in a home with already-updated plumbing lands near the low end. A 1970s Foster City bath with original galvanized lines lands near the high end. Our written estimates itemize every one of these lines, so you see the change before it happens, not after. Upfront pricing, no surprises, backed by our 730-Day Done Right Promise. Call (833) 997-7759 for an exact quote.
See the difference
Before
After
Before
After
Before
AfterWhat Foster City Homes Specifically Do to This Job
Foster City isn’t standard suburban checklist work. The city is built on imported fill ringed by levees and lagoons, and that engineered ground shows up inside the walls. Most of the tub-to-shower conversions we do here are in homes from the 1960s through 1980s build-out, slab-on-grade, with original utility lines now past their service life. That means our demo stage almost always uncovers something, and our rough plumbing stage is where the real budget decisions live. On the bay side of the lagoons, salt-laden onshore air accelerates corrosion on the original cast-iron drain fittings and on any metal behind the wall, so we plan for replacement rather than patching where the corrosion is visible.
The other Foster City reality is permitting and inspection. Much of the city sits within the flood plain on fill, and while a tub-to-shower conversion inside the conditioned envelope usually doesn’t trigger geotechnical or elevation review, it does require a plumbing permit and rough-in inspection, and sometimes a building permit depending on whether walls, framing, or the shower pan assembly are being altered. We pull the permits and schedule the inspections as part of the job. HOA rules matter too on the waterfront and lagoon-side associations, so check yours before glass or exterior venting selections are finalized.
Small bathrooms in the tightly spaced tracts near the lagoon-side neighborhoods leave little room for error on glass and curb layout, and the damp winters here make our 24-hour flood test and proper exhaust venting non-negotiable. If the wider bathroom needs work too (vanity, flooring, lighting), that’s usually best folded into a full Bathroom Remodeling in Foster City scope rather than done in two passes. Homeowners pairing exterior work often ask us about Metal Roofing in Foster City in the same season, since bay air wears on exterior finishes too. We cover the whole of Foster City, including the lagoon-side tracts off Beach Park Boulevard and the homes near the Central Park and Port Royal areas.
Serving Foster City, CA – Our Local Coverage Area
We serve Foster City and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked: Tub-to-Shower Conversion in Foster City
A tub-to-shower conversion typically takes 5 to 8 working days from demo to final inspection, plus a day for flood-testing and a day of grout cure before the shower sees water. Tile-heavy jobs and original-plumbing replacements push toward the longer end. Call (833) 997-7759 to lock in your schedule.
Yes, a plumbing permit is required, and a building permit may be required if walls, framing, or the pan assembly are altered. We pull the permits and schedule the rough-in and final inspections as part of the job, so you’re not chasing the city yourself. Call (833) 997-7759 for a scope walkthrough.
In most cases, yes. A tub-to-shower conversion reuses the existing drain location and valve wall, so no relocation is needed unless you want a different shower configuration or the drain is corroded beyond service. When the original 1960s – 1980s galvanized lines are the issue, we quote the replacement clearly before doing it. Call (833) 997-7759 for an assessment.
Most Foster City tub-to-shower conversions land between $3,500 and $10,000, with the middle of that range covering the typical 1970s tract home with original plumbing. Demand-driven costs like frameless glass, large-format tile, and slab drain relocation push toward the top. Call (833) 997-7759 for an exact, itemized quote.
Every tub-to-shower conversion we do is covered by our 730-Day Done Right Promise: if it isn’t done right, we make it right, for two years after final walkthrough. That’s one of the longest workmanship guarantees in residential construction. Material warranties pass through from the manufacturer on top of that. Call (833) 997-7759 for the details.
Get a Free Tub-to-Shower Conversion Estimate in Foster City
Call (833) 997-7759 to schedule a free on-site estimate for your tub-to-shower conversion in Foster City. A live person answers, day or night, and we’ll schedule a walkthrough within a few days. At the visit you’ll get a written, itemized quote with every line broken out, plus recommendations on finish materials and any plumbing replacements we’d flag before demo. Our Bathroom Remodeling service covers the wider bath if the scope grows, and our technicians bring up to 12 years of experience to every job. Ask about $1,000 off projects over $10,000 and 0% financing for 18 months.
Written by the team at Groundwork Construction Co.