Fence
Kitchen remodeling
Bathroom remodeling
Home additions & ADU
Roofing
Windows & doors
Driveway & paversFree written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Chain Link Fence in Albany, CA: What It Costs and How Long It Takes
A chain link fence in Albany, CA typically runs $3,500 – $9,000 installed, with most residential jobs finishing in one to three days once the layout is set. The range covers a standard side-yard or backyard run with galvanized posts, tension wire, and a walk gate, but it climbs when lots are tight, soil is hard, or the run crosses concrete. For a firm number on your property, call (833) 997-7759 and we’ll walk the lot with you.
How We Build a Chain Link Fence in Albany, Start to Finish
Every job follows the same five stages. The durations below hold for a typical Albany backyard run; longer boundary fences stretch each stage a little.
Stage 1: Walkthrough and layout (day 1, about an hour). We meet you on site, confirm the fence line against your plat map, and mark post locations with paint. This is where you decide the height (4, 5, or 6 feet), gate placement, and whether the fence sits on the property line or a few inches inside it. On Albany’s narrow lots, that line decision matters more than buyers expect.
Stage 2: Utility check and permitting (day 1 to day 5, depending on city review). We call 811 to flag buried lines before anyone digs. If your run crosses a public right-of-way or exceeds the city’s height threshold, we pull the fence permit through Albany’s planning counter. The typical wait is a few business days; we schedule materials for the day after approval lands.
Stage 3: Demo and post setting (day 2, a full day). We remove the old fence, pull old footings, and auger new holes to depth, roughly 24 to 36 inches depending on post height and soil. Posts get set in concrete and cure overnight. You decide here whether to keep, relocate, or delete an existing gate.
Stage 4: Rails, mesh, and tension (day 3, half to full day). Top rail goes up, mesh is stretched with a come-along, and tension wire is tied at the bottom. We check every section by hand for slack.
Stage 5: Gates and final walkthrough (day 3, one to two hours). We hang gates, set latches and hinges, and walk the finished run with you. Anything off gets fixed before we pack up. The whole job sits under our 730-Day Done Right Promise.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Chain Link Options: The Choices That Actually Matter
Most of the decision comes down to a handful of options. Here’s how we frame each one:
- Galvanized vs. vinyl-coated mesh. Standard galvanized is the value pick at the low end of the range. Vinyl-coated (usually green or black) costs more and blends into landscaping better, and the coating adds years to the wire life in coastal air.
- Post gauge and size. 1⅝-inch line posts and 2⅜-inch terminal posts are the residential standard. Going heavier at gates and corners prevents sag over time.
- Height (4, 5, or 6 feet). Higher means taller posts, more concrete, and sometimes a permit. In Albany, 6-foot runs near a property line often trigger review.
- Gate type. A walk gate is standard; a drive gate needs heavier hinges and a braced post, which pushes cost up.
- Tension wire vs. bottom rail. Tension wire is cheaper; bottom rail holds shape better with dogs or kids pushing on the fence.
Some homeowners pair this with Concrete Driveways & Concrete Work in Albany when a gate lines up with a new apron, and a few ask about tear-out alongside Asphalt Driveways & Resurfacing in Albany while the yard is already torn up.
What a Chain Link Fence Costs in Albany, CA
Plan on $3,500 – $9,000 installed. That’s the full range we quote for Albany residential jobs. The low end covers a modest run on flat, open ground; the high end is a long boundary with heavy terminal posts, one or more gates, and demo of an existing fence.
The variables that move the number:
- Linear feet. The single biggest factor. A 60-foot side run and a 200-foot perimeter are different jobs entirely.
- Existing fence removal. Pulling old posts and footings adds labor and a dump fee.
- Soil and grade. Rocky or sloped ground slows the auger and can force deeper concrete.
- Gates. Each gate adds cost; a drive gate adds more.
- Permit scope. Right-of-way or over-height runs add a permit fee and a few days of waiting.
Your written estimate itemizes posts, mesh, gates, concrete, demo, and permit. It doesn’t include landscaping repair, replacing buried irrigation lines we uncover, or moving utility lines if work triggers a meter relocation. Those come up as separate line items only when the site demands it. Call (833) 997-7759 for an exact figure.
See the difference
Before
After
Before
After
Before
AfterHow Albany’s Housing Stock and City Hall Shape This Job
Albany is a small, fully built-out East Bay city, and nearly every fence here is a replacement rather than a new-build. That changes the work. The lot you’re fencing is likely a 1920s – 1950s bungalow or small ranch with a detached garage and a shallow, narrow side yard, and the old fence posts are often set shallow in clay that’s firmed up over decades. Our auger hits that when we dig new holes near Solano Avenue and along the Marin Avenue corridor, and it’s why we over-dig terminal post footings on Albany jobs rather than trusting the standard depth.
Permitting is another local layer. Fence permits here go through Albany’s planning counter, not a big county department, and staff review every over-height run and any fence near a public sidewalk. We bring the plat map and a drawn layout so review doesn’t bounce back. The wet-winter, fog-cooled climate also narrows the reliable installation window: exterior work in Albany tends to run between late spring and early fall, so a fall booking often lands on the calendar for the next dry stretch.
Serving Albany, CA – Our Local Coverage Area
We serve Albany and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked: Chain Link Fence in Albany
Most chain link fence installs here finish in one to three working days once the layout is marked. A short side-yard run with a single walk gate is a two-day job; a full perimeter with demo and permits stretches toward three days plus the permit wait. Call (833) 997-7759 to get a specific timeline for your lot.
It depends on height and location. Fences at or under the city’s standard residential height threshold usually don’t need a permit; runs over that height, or those near a public right-of-way, generally do. We check the current threshold and pull the permit ourselves when it’s required, so you’re not chasing the city hall counter.
Yes, in most cases. We call 811 before digging, and post holes land inside your yard footprint, clear of drain lines and footings. If a buried irrigation line or gas stub sits in the fence path, that’s a flag we bring up before we dig, not after. Expect a straightforward install for the vast majority of Albany yards.
Budgets land in the $3,500 – $9,000 range for a residential job, which works out to roughly $25 – $50 per linear foot installed depending on height, gate count, and grading. Heavier terminal posts and demo of an old fence push toward the high end. For a line-item quote on your lot, call (833) 997-7759 – our estimates are free.
Every job is covered by our 730-Day Done Right Promise: if the workmanship isn’t right, we make it right. That covers posts, tension, gates, and hardware for two full years. Material warranties follow the manufacturer; our technicians have up to 12 years of experience and build to the spec that keeps the fence standing through Albany’s wet winters.
Get a Free Chain Link Fence Estimate in Albany
We walk your property, measure the run, and hand you a written, itemized estimate for a chain link fence in Albany at no charge. No vague ranges, no change orders after the dig starts. Calls are answered by a live person around the clock, so dial (833) 997-7759 whenever it’s convenient. If the fence is part of a full Fence Installation in Albany scope, we’ll fold both into one plan. You can also see how our Fence Installation service works and confirm we cover Albany here.
Written by the team at Groundwork Construction Co.