Fence
Kitchen remodeling
Bathroom remodeling
Home additions & ADU
Roofing
Windows & doors
Driveway & paversFree written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Wood Fence in Daly City, CA: What the Job Actually Involves
A wood fence in Daly City typically runs $3,500 – $9,000 for a standard residential lot, with most properties landing in the $4,500 – $7,000 range. The work usually takes two to four days from demolition to final set, depending on length, gate count, and how much of the old fence has to come out of sand. Call (833) 997-7759 for a free on-site estimate. We’ll walk the line, check the posts, and give you a written line-item price before anything gets ordered.
How a Wood Fence Goes In, Stage by Stage
Every fence we build in Daly City follows the same sequence. The order matters because once the first post goes in the ground on a hillside lot, moving it costs real money. Here’s what happens and when.
Stage 1: Site walk and layout (day 1, 1 – 2 hours)
We walk the property line with you, confirm the fence height and style, and mark post locations with stakes and string. On sloped lots above the Mission Street corridor, this is also where we decide whether the fence steps down the grade in 6-inch or 12-inch increments. That decision changes post count and material by 10 – 15%, so it happens before anything is ordered.
Stage 2: Demolition and old-post removal (day 1, 2 – 4 hours)
If there’s an existing fence, it comes out on day one so we can see what’s actually in the ground. Posts set in the 1950s and 1960s were often sunk straight into sandy fill with no concrete collar, and we frequently find them rotted at the soil line while the top of the board still looks fine. You decide at this stage whether any salvageable panels stay.
Stage 3: Post setting and concrete cure (day 1 into day 2)
New posts are set in concrete to a depth suited to the soil condition we find, typically 24 – 36 inches. On the west-facing dunes where the sandy base runs deep, we dig deeper and use a wider concrete collar to resist the wind load off the Pacific. Concrete needs to cure before rails go on, which is why the fence isn’t finished in a single day.
Stage 4: Rails, pickets, and gates (days 2 – 3)
Rails go on first, then pickets, then the gate hardware and latches. A typical 100-foot run takes a crew one full day for pickets. You choose the picket cap and the gap spacing (tight for privacy, slightly open for wind pass-through) before this stage, not during.
Stage 5: Final walkthrough (last day, 30 minutes)
We walk the fence with you end to end: gate swing, latch catch, post plumb, board attachment. Any adjustments get made on the spot. The written workmanship coverage under our 730-Day Done Right Promise starts here, and you get it in writing, not a handshake.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The Options You’ll Choose Between
Wood isn’t one material. The species and grade you pick drives both the price and how the fence holds up in the damp west-side air. Here are the real choices.
- Cedar – the natural pick for Daly City’s fog. Cedar resists moisture and rot better than pine and takes a stain well. It costs more than a pressure-treated pine build, but it lasts considerably longer in a climate with little sun to dry the boards out.
- Pressure-treated pine – the lower-cost route. Fine for the back line or a rental property, but it needs re-sealing more often and will move and check as it dries. Expect a shorter service life on the foggy side of town.
- Board style: dog-ear, flat-top, or French Gothic – this is largely aesthetic and barely moves the price. What does move the price is picket width and thickness. Standard 1×4 or 1×6 pickets keep you in the low range; thicker or wider boards climb toward the top.
- Height (4 ft, 5 ft, or 6 ft) – 6-foot privacy runs are the most common request, but on a windy hillside lot a solid 6-foot wind sail puts real lateral load on the posts. Where wind exposure is high, we sometimes recommend a small gap between pickets or a stepped height.
- Gates – a standard walk gate adds modestly; a double drive gate costs more because of the heavier frame, hinges, and a drop rod. Count your gates before we quote.
- Finishes and hardware – a penetrating stain or a quality exterior sealant, plus hot-dip galvanized or stainless fasteners. Cheap fasteners are the fastest way to a fence that fails at the joints. We’ll spec hardware that matches the marine-layer moisture.
What a Wood Fence Costs in Daly City, CA
Our Daly City wood fence range is $3,500 – $9,000, and here’s what pushes a job to one end or the other.
- Linear footage – the single biggest driver. A short side-yard run sits near the low end; a full perimeter around a typical Daly City lot lands in the middle to upper range.
- Existing fence condition – clean removal of an old, rotted fence with posts buried in sandy fill takes time. If concrete footings have to be broken out, that adds labor.
- Grade and steps – a flat lot is cheaper than a steep hillside run where the fence has to step or rack down the slope. Stepping means more posts and more cuts.
- Material grade – cedar over pressure-treated pine, thicker pickets, and premium hardware move the number up. Standard pine with 1×4 pickets keeps it down.
- Gates and corners – each gate, corner, and return adds framing and hardware. A property line with several corners costs more than a straight run.
A written estimate from us lists footage, material grade, post spacing and depth, gate count, and disposal of the old fence as separate line items. What it won’t include unless we flag it: permit fees (if a permit is required for your specific height and location), and any landscape or hardscape repair after removal. We tell you up front what’s not included so there are no surprise change orders later.
See the difference
Before
After
Before
After
Before
AfterWhat Daly City Homes Do to This Job
Daly City sits on wind-blown sand and steep fog-belt slopes on the western flank of San Bruno Mountain, and that changes a wood fence job in ways flat-land Peninsula cities don’t see. On the hillside streets above the Mission Street corridor, we regularly dig into sandy fill where the original post footings were little more than a shallow hole. Shifting dune soils and the marine-layer moisture mean a fence that isn’t set deep enough will lean within a couple of seasons. The west side around Westlake and Serramonte stays damp year-round with little sun to dry the boards, so rot starts at the soil line and in the shaded joints long before a homeowner notices. Board selection and sealing matter more here than on the sunnier east side. Most of the homes we fence are post-WWII 1940s – 1960s stucco-over-frame tract houses on poured slabs set into graded hillside cuts, and the original property-line fences are usually past their service life. We cover the whole city across ZIP codes 94015, 94016, 94017, and 94014 – see our Daly City service-area page.
Serving Daly City, CA – Our Local Coverage Area
We serve Daly City and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked – Wood Fence in Daly City
Most residential wood fences take two to four days from demolition to final walkthrough. A short side-yard run can finish faster; a full perimeter on a stepped hillside line with multiple gates runs longer because of post-setting and concrete cure. Call (833) 997-7759 for a timeline on your specific property.
Many residential wood fences fall under local height and setback rules, and whether a permit is required depends on your fence height and location relative to the property line. We check the rules that apply to your lot before we build, so you don’t get a surprise inspection issue. Call (833) 997-7759 and we’ll walk through it.
In most cases yes. We work around existing plantings and hardscape where the fence line allows, and we flag any section that will need to come out before we start. If your removal uncovers an area you’d like to upgrade, homeowners often pair this with Paver Driveways in Daly City or Concrete Driveways & Concrete Work in Daly City, and we can quote both together.
Wood fences in Daly City generally run $3,500 – $9,000, driven by linear footage, material grade, slope, gate count, and old-fence removal. Cedar and thicker pickets sit at the higher end; standard pine sits lower. Call (833) 997-7759 for a written line-item quote – the estimate is free.
Every project is covered by our 730-Day Done Right Promise – if it’s not done right, we make it right, backed in writing. That’s one of the longest workmanship guarantees in residential construction. Call (833) 997-7759 to schedule your free estimate.
Get a Free Wood Fence Estimate in Daly City
We’ll come out, walk the property line, check what the old posts are sitting in, and hand you a written line-item price for your wood fence. No pressure, no vague bids. Call (833) 997-7759 and a live person answers any hour – we’ll set a time that works for you. If you’re ready for the wider project too, our Fence Installation in Daly City page covers the full scope, and everything we build runs through our Fence Installation service.
Written by the team at Groundwork Construction Co.