Kitchen remodeling
Bathroom remodeling
Home additions & ADU
Roofing
Windows & doors
Driveway & pavers
FenceFree written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Door Installation in Daly City, CA: What It Takes and What It Costs
Door Installation in Daly City runs $1,200 to $6,500 for most homes, with a standard exterior entry door landing around $1,800 to $3,200 installed and a reinforced, wind-rated entry climbing past $5,000. A single door swap takes one day; a full frame replacement with rot repair runs two to three. Call (833) 997-7759 and we’ll walk you through what your Daly City entry actually needs before anyone swings a hammer.
From Teardown to Final Swing: How a Door Installation Actually Runs
Here’s what the schedule looks like on a real Daly City door job, so you know what you’re deciding at each stage and when.
Stage 1: Measure and moisture check (day 1, about 90 minutes)
We pull the door, probe the surrounding framing with a moisture meter, and check the rough opening for square. On this fog belt, west-facing walls around Westlake read wet far more often than homeowners expect. This is where we find out whether this is a door swap or a door-plus-framing job, and we tell you before the estimate is final.
Stage 2: Demo and siding prep (day 1, two to four hours)
Old door comes out, and we cut back the stucco or siding to the framing so the new door can flash and seal correctly. If the wall board is rotted – common on fog-soaked walls above the Mission Street corridor – we remove it now, not after the door goes in. You approve any added rot repair with a written line item before we continue.
Stage 3: Rough framing and header (day 1 into day 2, two to five hours)
For a like-for-like swap the opening is already framed and this step is quick. Relocate a door, widen it, or hang a new header because the old one has sagged on the sand-graded slope, and this is where the hours go. Structural work on the opening is permitted work; that’s covered below.
Stage 4: Set, shim, flash, and seal (day 2, three to five hours)
The door goes in plumb and square, we foam and flash the perimeter, and we tape the weather barrier so wind and driving rain the onshore flow throws at Daly City stays out. Then thresholds, threshholds’ drain pans where applicable, and hardware. Sealing the top and sides correctly is the single best defense you have against the marine layer getting into your wall.
Stage 5: Trim, finish, and final walk (day 2 or 3, two to four hours)
Interior casing, paint touch-ups, exterior sealant, strike plate adjustment, and a demonstration of the lock and closer. We test the door open and shut a dozen times in front of you. You sign off, and the 730-Day Done Right Promise starts ticking.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The Door Choices You’ll Actually Weigh
Door installation comes down to five decisions. Here’s the honest trade-off on each.
- Fiberglass vs. steel vs. wood: Fiberglass handles the damp better than anything else and won’t dent – our default for Daly City entries. Steel is stronger and cheaper but rusts at any scratch on the coast. Wood looks best and ages worst; on a fog-soaked west wall it needs re-sealing every couple of years.
- Wind-rated vs. standard: On the hillside streets above Mission Street, an upgraded multi-point lock and reinforced strike are worth the extra $400 to $900. A standard door on a hard gusting day can flex and eventually fail at the latch.
- Insulated glass vs. solid slab: Glass panels bring light into a dim hallway but add $300 to $1,200 and lose some energy performance. Solid slabs win on privacy and cost.
- Prehung vs. slab: Prehung doors (frame included) run $200 to $600 more than a slab but install faster and give you a new, true frame. On a house from the 1950s with a settled opening, prehung almost always makes more sense.
- Brand and hardware: Therma-Tru entry systems and Mr-Glass doors and glass panels are the two we specify most often here. Barrette and ViewLux show up on the fence and entry-gate side of the same jobs. Hardware grade (deadbolt, closer, hinges) moves the price by a few hundred dollars and changes how long the door hangs straight.
What Door Installation Costs in Daly City, CA
Most Daly City door installation jobs land between $1,200 and $6,500, with a standard exterior entry at roughly $1,800 to $3,200 and a reinforced wind-rated entry reaching $4,000 to $5,500. Interior doors are far less: $350 to $900 per door installed, dropping on volume when you do a whole house.
Five things move the number:
- Size and type: A standard 36-inch entry sits at the low end. A double door, sidelights, or an oversized opening adds $1,500 to $4,000.
- Condition of the wall: Rot repair, re-stucco, and new flashing push a straightforward swap into framing-repair territory, adding several hundred to a couple thousand.
- Relocation or widening: Cutting a new opening or moving one means a header, permits, patching, and finish – the biggest single variable.
- Door grade and glass: Premium fiberglass systems and insulated glass panels sit at the top; a standard slab at the bottom.
- Permit scope: Like-for-like replacements typically don’t require a permit in Daly City. Altering the opening or the structure does, and we pull it.
A written estimate from us lists the door, labor, flashing, sealant, hardware, disposal, and any rot repair as separate line items. Upfront pricing, no surprises – the number you see is the number you pay. What it won’t cover is what we can’t see until demo: hidden rot, cracked headers on a settled hillside cut, or framing that’s gone soft. We flag it the day we find it and price it before we touch it.
See the difference
Before
After
Before
After
Before
AfterWhat Daly City Homes Specifically Do to This Job
Daly City is built on wind-blown sand dunes and steep fog-belt slopes on San Bruno Mountain’s western flank, and that changes door work here in ways flat Peninsula cities never see. West-facing walls from Westlake to Serramonte sit in marine moisture nearly year-round with little sun to dry them – and the entry door is the spot where that moisture gets in. We pull doors on 1950s stucco-over-frame homes and find the frame behind the trim already soft, long before anyone noticed a draft. On the steep streets above Mission Street, homes set on shallow foundations in sand can settle at the door opening first, and you get a door that sticks three months of the year. Many of these Daly City replacements fall outside permit scope; anything that alters the opening does not, and we pull permits and pass inspection rather than leave you with an unpermitted entry at resale.
If the same moisture is eating at your window frames, our Windows & Doors in Daly City page covers the wider envelope, and a lot of homeowners pair a new door with Chain Link Fence in Daly City work at the same time. When the whole entry is being redone together, that’s a conversation for Windows & Doors. We do this work across all of Daly City, ZIPs 94014, 94015, 94016, and 94017, and the surrounding Peninsula.
Two smaller notes. Some Daly City entries are under an HOA or a shared-wall arrangement in the Mission Street and El Camino corridors, so check before you pick a color or finish. And on a wind-loaded door, a quality storm door or a properly installed sweep does more for you than a bigger slab. If your home also needs a new fence line, Vinyl Fence in Daly City is the other job we do alongside entry work.
Serving Daly City, CA – Our Local Coverage Area
We serve Daly City and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked – Door Installation in Daly City
A standard entry or interior Door Installation in Daly City takes one day – usually four to seven hours from demo to finish. A job with rot repair, a new header, or an opening change runs two to three days. We schedule in writing before we start, and we don’t leave a door hanging unfinished overnight unless we have to.
A like-for-like replacement generally doesn’t require a permit; changing the opening, moving the door, or altering the framing does. We tell you which your job needs during the estimate, pull the permit when it’s required, and manage the inspection. You don’t have to chase the city.
Usually, yes. On a standard replacement the wall stays put and only the door, frame, and surrounding sealant are disturbed. The exception is an opening that’s settled or rotted – then we’re into framing and the price and timeline both move. We know which one it is before we quote.
Most jobs land between $1,200 and $6,500. Interior doors run $350 to $900 installed; a wind-rated exterior entry typically hits $4,000 to $5,500. Call (833) 997-7759 for an exact quote – estimates are free.
Every door we install is covered by the 730-Day Done Right Promise – if it isn’t done right, we make it right. That covers our workmanship for two full years, longer than most contractors in the area offer. The door manufacturer’s product warranty sits on top of that, and we hand you both in writing.
Get a Free Door Installation Estimate in Daly City
We’ll come out, measure your actual opening, probe for rot and wind load, and hand you a written, line-item estimate for Door Installation in Daly City – no deposit, no pressure. Calls are answered by a live person 24/7, and our technicians are background-checked and arrive in uniform. Call (833) 997-7759 to schedule your free estimate.
Written by the team at Groundwork Construction Co.