Driveway & pavers
Kitchen remodeling
Bathroom remodeling
Home additions & ADU
Roofing
Windows & doors
FenceFree written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Concrete Driveways & Concrete Work in Burlingame, CA: Cost, Timeline, and What Actually Happens
Concrete driveways and concrete work in Burlingame typically run $4,500 – $12,000 for a full driveway installation, with most single-car to double-car pours landing in the $6,000 – $9,000 range, and the job usually takes 3 – 5 working days from demo to the day you can park on it. The pour itself is one day. The cure is the part nobody warns you about. Call (833) 997-7759 for a free on-site estimate and we’ll walk the grade with you before anyone touches a shovel.
How we sequence a concrete job, stage by stage
Concrete rewards patience and punishes shortcuts. Here’s the actual order of operations, and where you’ll be asked to make a call.
Stage 1: Site walk, grade check, and layout (day 1, roughly 2 hours)
We measure the run from the street to the garage, check the slope, and look at what’s underground. On Burlingame’s older lots, that means locating the sewer lateral and any irrigation lines that cross the path. You decide the width, the apron shape, and whether the driveway stays at existing grade or gets raised to shed water toward the street. That decision is the one that comes back to bite people, so we spend time on it.
Stage 2: Demo and haul-off (day 1 – 2)
Old concrete, asphalt, or gravel comes out and goes to the dump. We confirm the base depth we’re working with. A driveway that cracked because the subbase was 2 inches of dirt instead of 6 inches of compacted aggregate will crack again if you pour on top of the same bad base.
Stage 3: Base prep and formwork (day 2 – 3)
We excavate to depth, compact the aggregate base in lifts, and set forms to the final grade. This is where most of the labor lives. You’ll confirm the finish direction, joint layout, and whether you want a thickened edge where the driveway meets the garage slab.
Stage 4: Pour and finish (day 3 – 4)
Concrete arrives, gets screeded, floated, and finished to the surface texture you picked. Control joints go in at planned intervals so the slab cracks where we want it to, not where it wants to. You don’t decide anything on pour day. That’s deliberate.
Stage 5: Cure and open to traffic (day 4 – 5, plus waiting)
Concrete reaches roughly 70% of its design strength in a week and full strength around 28 days. Foot traffic after 24 – 48 hours, vehicles after about 7 days in mild weather. Damp Burlingame mornings slow the set slightly, which is usually a good thing for strength. You decide when to schedule the sealing coat, if you want one.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The concrete options you’ll actually choose between
Concrete isn’t one product. The decisions below are what shift both the look and the number.
- Standard broom finish: The default for a reason. Textured, slip-resistant, hides tire marks, and the least expensive option in the range. Best for a driveway you intend to use hard and not think about.
- Exposed aggregate: The top layer of cement is washed away to reveal the stone. More grip, more visual texture, and it holds up well in wet weather. Runs higher than broom and needs occasional resealing.
- Colored and integral pigment: The color goes into the mix rather than sitting on top, so it won’t wear off under tires. Charcoal and warm tan are the common picks. Adds cost per square foot over plain gray.
- Reinforcement: Wire mesh or rebar. On Burlingame’s older, sometimes uneven subgrades, rebar in a properly thickened slab is worth the money. Mesh is cheaper and adequate on a well-compacted base.
- Thickness: 4 inches is the floor for a residential driveway. 5 – 6 inches with a thickened edge is the honest recommendation if a heavier vehicle parks there or the base is marginal.
For a full hardscape plan around the pour, our Driveway & Pavers service covers the wider scope. If the frontage is part of a bigger remodel, it’s often worth pairing with the Driveway & Pavers in Burlingame work on the same site.
What Concrete Driveways & Concrete Work costs in Burlingame, CA
Concrete driveway installation in Burlingame ranges from about $4,500 to $12,000. A full replacement that includes demo and haul-off runs $5,000 – $14,000. Those ranges cover the work most homeowners actually need.
| Line item | Burlingame range |
|---|---|
| Concrete driveway installation | $4,500 – $12,000 |
| Full driveway replacement (demo + pour) | $5,000 – $14,000 |
| Driveway sealing | $250 – $700 |
What pushes a job toward the high end: square footage, obviously, but also the condition of what’s underneath. A base that needs full excavation and re-compaction adds days and dollars. A driveway that crosses a utility trench may need protection or a thicker slab. Upgrading to colored or exposed aggregate moves the number up. A permit and inspection requirement moves it up again. What doesn’t change: the number in our written estimate. Upfront pricing, no surprises, and a written line-item quote you can hold us to.
See the difference
Before
After
Before
After
Before
AfterWhat Burlingame homes specifically do to this job
Driveways in Burlingame Park and Easton Addition aren’t poured on clean, flat lots. They’re poured between narrow setbacks on lots that date to the early 1900s through the 1940s, where the original drive was likely gravel or a shallow slab poured decades before anyone worried about drainage. We routinely find the old base sitting on fill, tree roots lifting one corner, and a garage slab that has settled independently of the house. Burlingame’s cool, fog-influenced summers and damp winters mean the persistent morning moisture works on every joint and edge, so proper grading and a real base aren’t optional here. The city’s design-review process matters most on additions and second stories, but a driveway that changes the front setback or drainage pattern can still trigger review, so we check before we dig.
Serving Burlingame, CA – Our Local Coverage Area
We serve Burlingame and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently asked: Concrete Driveways & Concrete Work in Burlingame
A standard residential pour takes 3 – 5 working days from demo to finished slab, then about a week before you park on it. Weather and base condition are the two variables that stretch it. Call (833) 997-7759 and we’ll give you a realistic schedule for your address, not a generic one.
Often no for a straight driveway replacement at existing grade, and usually yes when the work changes drainage, setbacks, or connects to a new structure. The rule depends on the scope, not the material. We confirm what your specific project needs before any work starts, and if permits are required, we pull them.
Most jobs land between $4,500 and $12,000, with full replacements at $5,000 – $14,000. Size, base condition, finish, and permit scope move the number. Call (833) 997-7759 for an exact quote; estimates are free and on-site.
Yes, in most cases. Standard driveway work doesn’t touch the house’s plumbing or framing. The exception is a sewer lateral or utility line running under the path; we locate those first, and if one needs relocation, we tell you before we quote rather than after demo. Homeowners doing larger site work often pair this with a Garage Conversion ADU in Burlingame or a New Detached ADU in Burlingame, where the driveway access becomes part of the plan.
Every concrete job we do is covered by the 730-Day Done Right Promise: if it isn’t done right, we make it right. That’s one of the longest workmanship guarantees in residential construction, and it’s in writing. Questions? Call (833) 997-7759, answered by a live person 24/7.
Get a free estimate on your Burlingame concrete project
We’ll come out, measure the run, check the base, and give you a written line-item estimate with no pressure and no vague “starting at” language. We cover all of Burlingame, including the 94010 and 94011 ZIPs. Call (833) 997-7759 to schedule your free estimate. A live person answers any hour, and you’ll know the real number before you commit to anything.
Written by the team at Groundwork Construction Co.